This unique stile and rail set allows you to easily produce glass panel doors utilising a rubber panel retainer to secure the glass in a 3.2mm slot cut into the frames. Machine all pieces face down. This set works the same as the other CMT stile and rail sets but leaves you with a square rebate on the inside of your door for installing the glass panel. Machine all pieces face down.After machining the cope and pattern cuts use the 3,2 mm slot cutter to cut the groove for the rubber panel retainer. The edge of the pattern cut will ride on the guide bearing of the slot cutter bit. When you cut the slot in the rails you can cut the slot the full length of the stock. When you cut the slot in the stiles you need to set up reference points to stop and start the cuts so they are hidden from view on the top and bottom of the doors. Available with 1/2" shanks.